BICSI International Standards Program

interior header

ANSI/NECA/BICSI 568-2006, Standard for Installing Commercial Building Telecommunications Cabling



In 1998, a large number of companies representing the telecommunications and electrical industries expressed concern over the lack of a standard for installation of telecommunications premises cabling systems.

The National Electrical Contractors Association (NECA) asked BICSI to jointly undertake the task of developing the required standard. BICSI accepted the task and the project was assigned to BICSI/NECA Joint Technical Committee 1 for the “Development of Telecommunications Cabling Installation Guidelines.”

NECA/BICSI 568 describes minimum requirements and procedures for installing the infrastructure for telecommunications, including balanced twisted-pair copper cabling and optical fiber cabling that transport telecommunications signals (e.g., voice, data, video). This standard also is intended to be used in describing a “neat and workmanlike manner,” as referenced by ANSI/NFPA 70, the National Electrical Code® (NEC®).

The 2008 NEC references the standard in Article 800.24: Mechanical Execution of Work, as a Fine Print Note that states: “Accepted industry practices are described in ANSI/NECA/BICSI-568-2006, Standard for Installing Commercial Building Telecommunications Cabling;…” The 2008 NEC is a safety code widely adopted in the United States as minimum required safety rules for the electrical industry and points to the ANSI/NECA/BICSI standard as a best practices source document.

Table of Contents

1. Scope

2. Definitions, Acronyms, Abbreviations, and Units of Measure

3. Support Structures

4. Pulling Cable

5. Firestopping

6. Cable Terminations

7. Installation Verification

Annex A: Field Test Requirements

Annex B: Reference Standards

ANSI/NECA/BICSI Standards 568-2006


Healthcare Standard